___________________________
Reading faults for: Power Inverter Module
___________________
Faults reported:

20. 8. 2025 21:49:00
Faults found.
P167B
___________________
___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: Power Inverter Module
___________________
Faults reported:

20. 8. 2025 21:49:15
Faults found.
P167B
___________________
Error code: P167B
Controlled System Shutdown

Last test completed unsuccessfully
Error present
Failure warning lamp 'ON': Not requested

Error code: P167B
Controlled System Shutdown

Last test completed unsuccessfully
Error present
Failure warning lamp 'ON': Not requested

___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: Power Inverter Module
___________________
Faults reported:

20. 8. 2025 21:56:04
Faults found.
P167B
___________________
___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: Power Inverter Module
___________________
Faults reported:

20. 8. 2025 22:58:18
Faults found.
P167B
___________________
___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: Power Inverter Module
___________________
Faults reported:

25. 8. 2025 19:50:17
Faults found.
P167B
___________________
___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: Power Inverter Module
___________________
Faults reported:

28. 8. 2025 20:42:38
Faults found.
P167B
___________________
___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: Power Inverter Module
___________________
Faults reported:

29. 8. 2025 19:16:03
Faults found.
P167B
___________________
___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: Power Inverter Module
___________________
Faults reported:

1. 9. 2025 19:56:44
Faults found.
P167B
___________________
___________________________
'Clear fault codes' command sent

Odometer: 97618,00 km
Odometer at last rewrite: 0,00 km
Number of rewrites: 0
Functioning time (eeprom): 483543 min
Time since Key-On (eeprom): 30 sec
ECU Time Stamps (RAM): 483547 min
ECU Time Stamps From Key On (RAM): 195 sec
Key On Counter (EEPROM): 17536
ECU Time first DTC detection (EEPROM): 483541 min
ECU Time Stamps from KeyOn first DTC detection (EEPROM): 60 sec
Key-On counter alignment: 0
Resolver offset Calibration Status: Offset Calibration Not Needed
Learned Resolver Offset Angle: 143,25 °
Flux Learning Needed Status: No
Learned Flux Value: 0,03 V/sec
PIM Operation Mode Value: Discharge
Derating Status - Motor Torquee: Derating Inactive
Master EV Wakeup Value: On
Derating Status - generator torque Value: Derating Inactive
DCDC Operation Mode: Standby
DCDC Requested Mode: Off
Status request mode PIM: go_DisCharge
PIM Operation Mode Value - CAN Output Value: Discharge
Derating Status - Motor Torque Value - CAN Output Value: Derating Inactive
Derating Status - Generator Torque Value - CAN Output Value: Derating Inactive
DCDC Operation Mode - CAN Output Value: Off
Resolver Offset Routine Status Value: Not Tested
______________________