___________________________
Reading faults for: On-Board Charging Module
___________________
Faults reported:

20. 8. 2025 21:28:42
Faults found.
U1202
___________________
___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: On-Board Charging Module
___________________
Faults reported:

20. 8. 2025 21:55:52
No faults reported by the unit.
___________________
___________________________
Reading faults for: On-Board Charging Module
___________________
Faults reported:

22. 8. 2025 18:07:17
Faults found.
U0111
___________________
Error code: U0111
Lost Communication With Battery Energy Control Module

Last test completed positively
Error present
Failure warning lamp 'ON': Not requested

Error code: U0111
Lost Communication With Battery Energy Control Module

Last test completed positively
Error present
Failure warning lamp 'ON': Not requested

___________________________
'Clear fault codes' command sent

___________________________
Reading faults for: On-Board Charging Module
___________________
Faults reported:

25. 8. 2025 18:49:23
No faults reported by the unit.
___________________
___________________________
Reading faults for: On-Board Charging Module
___________________
Faults reported:

25. 8. 2025 19:42:45
No faults reported by the unit.
___________________
___________________________
Reading faults for: On-Board Charging Module
___________________
Faults reported:

28. 8. 2025 20:16:48
No faults reported by the unit.
___________________
___________________________
Reading faults for: On-Board Charging Module
___________________
Faults reported:

28. 8. 2025 20:38:28
Faults found.
U1202
U0111
___________________
___________________________
'Clear fault codes' command sent

Odometer at last rewrite: 25,50 km
Odometer at last rewrite: 25,50 km
Number of rewrites: 1
Functioning time (eeprom): 9358 min
Time since Key-On (eeprom): 8895 sec
ECU Time Stamps (RAM): 13 min
ECU Time Stamps From Key On (RAM): 795 sec
Key On Counter (EEPROM): 154
ECU Time first DTC detection (EEPROM): 0 min
ECU Time Stamps from KeyOn first DTC detection (EEPROM): 0 sec
Key-On counter alignment: 0
OBCM Status AC Present: AC Not OK
AC Line Low: Not valid
AC Line High: Not valid
Battery Not Detected: No
Battery Voltage Under Min: Yes
Battery Voltage Over Max: Yes
BPCM HV Battery Contractor Open: No
HV OC: No
HV OV: No
NTC1 OT: No
NTC2 OT: No
NTC3 OT: No
NTC4 OT: No
J1772 S2 Close: Open
J1772 State: Connection Not Ready
J1772 S2 Status: Open
EVSE Pilot State: CP DET
Prox State: Prox IN
OBC Charge Time, sec: 0 sec
OBC Charge Time, hours: 11803 H
OBC Idle Time, sec: 21 sec
OBC Idle Time, hours: 225 H
OBCM Mode: Idle
OBCM Charger Ready: On
OBCM WU Status: On
Charge Enable Status: Disabled
EVCU Shutdown Command: EVCU Operational
EVCU Enable Charge Command: Disabled
EVCU OBC Mode Request: Idle
Generic Fail Sts: No Functional Fail Present
Charge Fail Statue: Fault Detected
OBC Control Method: Current
Close Charge Contractor: Open
Charge Contractor State: Not defined
Charge Mode: Charge Mode
EVCU Wake Up Input: Wakeup is Faulted
BPCM Wake Up Input: Wakeup is Faulted
OBCM - HV Over Voltage Protect: No
OBCM - LV Aux Over Voltage Protect: No
OBCM - LV Aux Under Voltage Protect: No
OBCM - LLC Over Voltage Protect: No
OBCM - LLC Under Voltage Protect: No
OBCM - PFC Over Voltage Protect: No
OBCM - PFC Under Voltage Protect: No
OBCM - Battery 12V Under Voltage Protect: No
OBCM - Battery 12V Over Voltage Protect: No
OBCM - AC Under Voltage Protect: No
OBCM - AC Over Voltage Protect: No
OBCM - AC Over Current Protect: No
OBCM - HV Voltage Over MaxCal Protect: No
OBCM - HV Over Current Protect: No
OBCM - Power Stage Over Voltage Protect: No
OBCM - Internal Memory Fault: No
OBCM - Over Temperature Protect: No
OBCM - HCP Loss of Communication Protect: No
OBCM - Loss BPCM Communication Protect: No
OBCM - CAN Bus Off: No
OBCM - Pilot Duty Fault: No
OBCM - Prox Range Too Low: No
OBCM - Prox Range Too High: No
OBCM - HV Voltage Under MinCal Protect: No
OBCM - SPI Communication Fault: No
OBCM - Pilot Short To Battery: No
OBCM - WakeUp Output Stuck Low: No
OBCM - WakeUp Output Stuck High: No
OBCM - ORC Loss of Communication Protect: No
OBCM - HV Battery Not Contact: No
OBCM - Loss Communication Protect: No
OBCM - Receive HV Battery Contact Open From BPCM: No
OBCM - Secondary Aux Over Voltage Protect: No
OBCM - Secondary Aux Under Voltage Protect: No
OBCM - Primary Aux Over Voltage Protect: No
OBCM - Primary Aux Under Voltage Protect: No
OBCM - Stuck Shutdown: No
OBCM - Cycle Shutdown: No
OBCM - HV Under Voltage Protect: No
OBCM - Vehicle Impact: Yes
OBCM - ARC/CRC Fault: No
OBCM - AC Contact Welded Fault: No
Loss ECM/PCM Communications Protect: No
OBCM - Aux Into Pilot Switch Low Fault: No
OBCM - Aux Into Pilot Switch High Fault: No
OBCM - Pilot Range Fault: No
OBCM - Prox Range Fault: No
OBCM - Pilot Open Fault: No
OBCM - Prox Open Fault: No
OBCM - Internal S2 Switch Low Fault: No
OBCM - Internal S2 Switch High Fault: No
BPCM Wake Up Input Stuck Low Fault: No
BPCM Wake Up Input Stuck High Fault: No
HCP Wake Up Input Stuck Low Fault: No
HCP Wake Up Input  Stuck High Fault: No
OBCM - Wake Up Output Open Fault: No
Module A Primary - AC Under Voltage Protect: No
Module A Primary - PFC Power Limit: No
Module A Primary - PFC Enable States: No
Module A Primary - LLC Enable States: No
Module A Primary - PFC Under Voltage Protect: No
Module A Primary - PFC Over Voltage Protect: No
Module A Primary - Over Temperature Protect: No
Module A Primary - Hot Warning: No
Module A Primary - AC Present: No
Module A Primary - PFC Over Temperature Protect: No
Module A Primary - LLC Over Temperature Protect: Yes
Module A Primary - PFC Hot Warning: No
Module A Primary - LLC Hot Warning: No
Module A Primary - AC Over Voltage Protect: No
Module A Primary - Relay Enable States: No
Module A Primary - Aux Over Voltage Protect: No
Module A Primary - Aux Under Voltage Protect: No
Module A Primary - Secondary Micro Enable Command: No
Module A Primary - AC Vin Lost: No
Module A Primary - Loss Communication Protect: No
Module A Primary - Standby Mode: No
Module A Primary - Operate Mode: No
Module A Primary - Shutdown Mode: Yes
Module A Secondary - Aux Enable States: No
Module A Secondary - HV Enable States: No
Module A Secondary -  LLC Under Voltage Protect: No
Module A Secondary -  LLC Over Voltage Protect: No
Module A Secondary - HV Over Voltage Protect: No
Module A Secondary - HV Over Current Protect: Yes
Module A Secondary - Over Temperature Protect: No
Module A Secondary - Hot Warning: No
Module A Secondary - HV Over Temperature Protect: No
Module A Secondary - Ambient Over Temperature Protect: No
Module A Secondary - HV Hot Warning: No
Module A Secondary - Ambient Hot Warning: No
Module A Secondary - Aux Over Voltage Protect: No
Module A Secondary - Aux Under Voltage Protect: No
Module A Secondary - Loss Primary Communication Protect: No
Module A Secondary - LV Micro Enable Command: No
Module A Secondary - Loss LV Communication Protect: Yes
Module A Secondary - Primary Turn On States: No
Module A Secondary - Primary Shutdown States: No
Module A Secondary - HV Under Voltage Protect: No
Module A Secondary - Standby Mode: No
Module A Secondary - Operate Mode: No
Module A Secondary - Shutdown Mode: No
Module B Primary - AC Under Voltage Protect: No
Module B Primary - PFC Power Limit: No
Module B Primary - PFC Enable States: No
Module B Primary - LLC Enable States: No
Module B Primary - PFC Under Voltage Protect: No
Module B Primary - PFC Over Voltage Protect: No
Module B Primary - Over Temperature Protect: No
Module B Primary - Hot Warning: No
Module B Primary - AC Present: No
Module B Primary - PFC Over Temperature Protect: No
Module B Primary - LLC Over Temperature Protect: No
Module B Primary - PFC Hot Warning: No
Module B Primary - LLC Hot Warning: No
Module B Primary - AC Over Voltage Protect: Yes
Module B Primary - Relay Enable States: No
Module B Primary - Aux Over Voltage Protect: No
Module B Primary - Aux Under Voltage Protect: No
Module B Primary - Secondary Micro Enable Command: No
Module B Primary - AC Vin Lost: No
Module B Primary - Loss Communication Protect: No
Module B Primary - Standby Mode: No
Module B Primary - Operate Mode: No
Module B Primary - Shutdown Mode: No
Module B Secondary - Aux Enable States: No
Module B Secondary - HV Enable States: No
Module B Secondary -  LLC Under Voltage Protect: No
Module B Secondary -  LLC Over Voltage Protect: Yes
Module B Secondary - HV Over Voltage Protect: No
Module B Secondary - HV Over Current Protect: No
Module B Secondary - Over Temperature Protect: No
Module B Secondary - Hot Warning: No
Module B Secondary - HV Over Temperature Protect: No
Module B Secondary - Ambient Over Temperature Protect: No
Module B Secondary - HV Hot Warning: No
Module B Secondary - Ambient Hot Warning: No
Module B Secondary - Aux Over Voltage Protect: No
Module B Secondary - Aux Under Voltage Protect: No
Module B Secondary - Loss Primary Communication Protect: Yes
Module B Secondary - LV Micro Enable Command: No
Module B Secondary - Loss LV Communication Protect: No
Module B Secondary - Primary Turn On States: No
Module B Secondary - Primary Shutdown States: No
Module B Secondary - HV Under Voltage Protect: Yes
Module B Secondary - Standby Mode: No
Module B Secondary - Operate Mode: Yes
Module B Secondary - Shutdown Mode: No
OBCM Plant Mode: Normal Mode (Application)
Charging Test Status: Test Passed
Charging Test Failure Code: Not Programmed
J1772 Pilot Circuit Status: CP DET
J1772 Proximity Circuit Status: Prox IN
J1772 Encoded State: Connection Ready No Vent
______________________